三星贴片机CP20,CP33,CP40-SA激光曲线调整教程

-
Work procedure
; L6 e. R: G6 X8 P5 Y; e: m% CHow to adjust the Profile
1. Drive the MMI.
2. Execute the SA COMM.EXE(C:\SACOMM\SA COMM.EXE).
3. Connect the RS-232 Cable.
4. Turn off the SCM BOARD DIP S/W. (Facing upwards) - Refer to Figure 1.
2 o6 C' N( S$ q# [5. Press the RESET S/W.
6. Select the PROFILE.
7. Move down HEAD Z axis to reveal the edge.
8. Adjust the Volume Resistance, V2, to set the OFFSET.
9. Adjust the Volume Resistance, V1 and V3, to position the PROFILE within standard
range (GRAY Level: 200 + 20).
Adjust V3 to control bright of LED, and make the shape of PROFILE to Wave type.
8 u5 w* g/ L" HAdjust V1 to set the GRAY Level to 200 + 20.
10.Select the STOP.

0 D7 P1 u" j- t. V
1 M! z. |4 o* Y" ?& M! A5 Y$ _完整版下载附件查看

支持，赞一个

这么强,支持楼主，佩服

向楼主学习

向楼主学习

看帖要回，回帖才健康，在踩踩，楼主辛苦了！